azonenberg:nintendo:3ds_xl_cpu
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
azonenberg:nintendo:3ds_xl_cpu [2014/03/23 23:54] – azonenberg | azonenberg:nintendo:3ds_xl_cpu [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{tag> | ||
- | SoC from the [[azonenberg: | ||
- | |||
- | ====== Package ====== | ||
- | |||
- | {{: | ||
- | |||
- | Markings: | ||
- | |||
- | 1226 60 | ||
- | CPU CTR A | ||
- | (M) (C) 2010 | ||
- | (Nintendo logo) | ||
- | JAPAN (ARM logo) | ||
- | |||
- | ====== Die ====== | ||
- | |||
- | Size is approximately 6640 x 6450 μm (42.8 mm< | ||
- | |||
- | Overview. Not the greatest stitch, the surface was so repetitive it was hard to get good results. | ||
- | |||
- | {{: | ||
- | |||
- | Bond pads. Note paired power/ | ||
- | |||
- | {{: | ||
- | |||
- | Thick vertical power distribution wiring on top metal. It connects through large (un-plugged) vias to the next layer down, the horizontal power routing can be seen at left. The top and bottom areas of the die have more widely spaced power routing but the middle has them very closely packed. This suggests that the most power-hungry part of the device is in the center. | ||
- | |||
- | {{: | ||
- | |||
- | Test pads (?) in upper left corner of die. At least four metal layers are visible before they become too small to see: N (yellow, vertical thick power distribution), | ||
- | |||
- | {{: | ||
- | |||
- | Part number marking at upper right corner of die. | ||
- | |||
- | {{: | ||
- | |||
- | Close-up view of global power distribution. | ||
- | |||
- | {{: | ||
- | |||
- | Another view through a hole down into the depths of the device. Seems like at least six layers are visible here but they' | ||
- | |||
- | {{: |
azonenberg/nintendo/3ds_xl_cpu.1395618858.txt.gz · Last modified: 2014/03/23 23:54 by azonenberg