prog:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
prog:start [2013/03/15 06:31] – mcmaster | prog:start [2015/01/04 22:50] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 4: | Line 4: | ||
* Read chips 2 or 3 times to make sure its reliable. | * Read chips 2 or 3 times to make sure its reliable. | ||
* Polish pins to remove oxide layer. | * Polish pins to remove oxide layer. | ||
- | | + | |
- | * Undervolting | + | From Lord Nightmare as taught by Guru: |
+ | | ||
+ | * Undervolting | ||
Line 43: | Line 45: | ||
A programmer JM use to have. Programmed via serial port. It seemed quirky and my particular unit seemed defective/ | A programmer JM use to have. Programmed via serial port. It seemed quirky and my particular unit seemed defective/ | ||
+ | |||
+ | |||
+ | ====== Xeltek ====== | ||
+ | |||
+ | Lower cost than BP Micro but also looks like less support | ||
+ | |||
+ | |||
+ | ====== BP Micro ====== | ||
+ | |||
+ | High quality but reasonably expensive programmers | ||
+ | |||
+ | [[bp_micro|Main page]] | ||
prog/start.1363329081.txt.gz · Last modified: 2013/03/15 06:31 by mcmaster