Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
components [2012/03/18 10:16] azonenbergcomponents [2012/07/04 18:07] – [Substrate] azonenberg
Line 11: Line 11:
 {{gallery>image:bond_pad.jpg}} {{gallery>image:bond_pad.jpg}}
  
-======   ======  +See [[pad|main article]]
-Connects bonding wires to the die. Large metal pads so the wire can be attached without high precision. The inner box is the overglass covering part of the aluminium so as to be able to make a good contact and still maintain a good seal. +
- +
-Still has a bond wire on it: +
-{{gallery>image:overglass_1.jpg}} +
- +
-Damaged overglass: +
-[[image:damaged_overglass.jpg]] +
-It is very fragile and can easily get completely stripped during decapsulation. +
- +
-Aluminium (M1) errosion from excessive time in acid bath: +
- +
-{{gallery>image:overglass_acid_seep.jpg}} +
- +
  
 ====== Straining ======  ====== Straining ====== 
Line 85: Line 71:
  
 ====== Substrate ======  ====== Substrate ====== 
-The majority of the mass of the die. Some sort of SiO2 varient. Generally fairly boring and not much worth noting.+The majority of the mass of the die. Usually just a large block of siliconThe surface of a CMOS wafer is typically oriented along the <100> direction, many bipolar devices use <111>. <110> wafers are usually only seen in specialized applications such as MEMS. 
 + 
 +Generally fairly boring and not much worth noting.
  
 ====== References ======  ====== References ====== 
 
components.txt · Last modified: 2013/10/20 14:59 by 127.0.0.1
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki