Differences

This shows you the differences between two versions of the page.

--- semi-invasive [2018/02/25 09:11] – mcmaster
+++ semi-invasive [2019/12/08 19:22] – mcmaster
@@ Line 1: / Line 1: @@
-====== Photonic (UV) flash erasure ======
+====== UV EPROM erase ======
-Flash
+EPROM/EEPROM/flash can be erased by shining UV light or x-rays into the surrounding oxide. This slightly oxidizes it, letting the floating gate to drain out.
-====== Non-invasive attacks ======
+Usually a masking compound is applied to selectively block UV to the firmware, with red nail polish being the most popular or at least traditional.
-[[jtag|JTAG]]
+{{:mcmaster:nail_polish:overview.jpg?400|}}
-[[ripping|Ripping firmware]]
+McMaster misc notes
-[[dpa|Differential power analysis]]
+Application
+  * Use a single hair brush
+    * Ex: cut down MG 855-5 horse hair brush
+  * Place chip in bowl
+  * Shallow fill bowl with acetone
+    * Creates shield gas to prevent nail polish drying out in small quantities
+    * Place paper towel on side to elevate gas enough to keep nail polish liquid
+  * If nail polish is too viscous, slightly set top of chip with IPA
+  * Apply a glob of nail polish, then use the spring force of the liquid to precisely move it around
+    * By gently agitating the liquid boundaries its possible to very precisely move it forward
+  * Place the nail polish in the bowl in some sort of holder
+    * Ex: above image has a 1/4-20 SHCS with a nut screwed on as a base
+Nail polish
+  * [[https://www.amazon.com/gp/product/B00LT8S30G/|Revlon ColorStay Gel Envy Longwear Nail Enamel, Queen of Hearts]]
+  * Bought at local store a while back and it seems to work well enough
+  * Other colors probably fine, but red is easy to see
+{{:mcmaster:nail_polish:pipette.jpg?400|}}
+Above: fine polypropylene tip for more aggressive cleaning. The tool is strong enough to damage bond wires though, so use sparingly
+Nail polish removal
+  * Bulk removal with acetone, but leaves some residue around edges
+  * Remaining residue softened with acetone
+  * Remove using single hair brush if possible
+  * Can be more aggressive with PP monofilament wire
+  * Cold H2SO4 also works well. Wash with IPA then acetone
+    * Washing with water may really heat up the mixture
+===== Angle =====
+Some chips with shielding against this type of attack can be bypassed by shining light at a sharp angle
+===== Mask =====
+Use nail polish or similar compound. Most materials will block UV, so just about anything will work. Nail polish tends to be easy to work with including application and (acetone) removal.
+Use a fine point pipette for simple chips.
+For finer masks, place the chip in a large bowl with a shallow layer of acetone at the bottom. This creates an acetone "shield gas" to prevent tools from drying out. Then put some nail polish on a single bristle (maybe held by tweezers) and it should not dry out, allowing you to paint it onto the die.
+====== X-ray EPROM erase ======
+TODO: add links to misc papers