Differences

This shows you the differences between two versions of the page.

--- 4e71:microchip:pic12f609 [2025/05/19 19:24] – mcmaster
+++ 4e71:microchip:pic12f609 [2025/05/19 22:34] (current) – mcmaster
@@ Line 22: / Line 22: @@
 {{:4e71:microchip:pic12f609:chips_mill.jpg?300|}}
 {{:4e71:microchip:pic12f609:p5192068.jpg?300|}}
+"Yes, as someone here mentioned if you're quite careful you can bend the pins back 180 degrees one time without breaking them. Then I use this adapter I made to allow flipping the sides of the socket to allow direct connection of the inverted chip. Pic #1 is the 'scope setup with the trailing socket from the programmer on levelling/rotation table. Pic #2 is normal connection to programmer for normal chip pin to pin connection. Pic #3 is with the adapter added for flipping the pins on each side of the socket to allow connection of inverted chip with legs bent back 180 degrees. Pic #4 is the adapter, you solder direct pin to pin right down one side and then add wires connecting the opposite side pins. Pic #5 is the adapter from below. This allows flipped chip with bent legs to sit in normal position in ZIF socket and still be read as normal. 🙂 "
 {{:4e71:microchip:pic12f609:milling1.jpg?300|}}