Autopsy: JM

Source: AZ through some random guy at RPI

The case was removed using acetone and later a heat gun.  The acetone only made it marginally softer after soaking for an hour.  I probably should have used the heat gun earlier as it did help a lot.  However, you have to be very careful to maintain good temperature so as to not damage (melt or burn) the PCB.  The acetone does help though as while it doesn't significantly break apart the structure it does make it a little easier to take off of the PCB.


====== Case ======

{{gallery>:rsa:securid:gray:azjm:case:cimg1907.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1910.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1912.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1913.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1916.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1918.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1932.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1933.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1939.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1943.jpg}}
{{gallery>:rsa:securid:gray:azjm:case:cimg1963.jpg}}


====== PCB ======

===== Top =====


{{gallery>:rsa:securid:gray:azjm:pcb:top:cimg1966.jpg}}
{{gallery>:rsa:securid:gray:azjm:pcb:top:cimg1986.jpg}}
{{gallery>:rsa:securid:gray:azjm:pcb:top:cimg1992.jpg}}
{{gallery>:rsa:securid:gray:azjm:pcb:top:cimg1994.jpg}}

===== Bottom =====


{{gallery>:rsa:securid:gray:azjm:pcb:bottom:cimg1968.jpg}}
{{gallery>:rsa:securid:gray:azjm:pcb:bottom:cimg1978.jpg}}
{{gallery>:rsa:securid:gray:azjm:pcb:bottom:cimg1980.jpg}}
{{gallery>:rsa:securid:gray:azjm:pcb:bottom:cimg1983.jpg}}