Differences

This shows you the differences between two versions of the page.

--- equipment:vacuum:gp:igc [2013/08/17 22:55] – mcmaster
+++ equipment:vacuum:gp:igc [2013/10/20 14:59] (current) – external edit 127.0.0.1
@@ Line 22: / Line 22: @@
 {{:equipment:vacuum:gp:307:manual_fig1-7.png?450|}}
+The DA-15 male-male connector between the two units is straight through.  Shields are connected on both D-sub connector sides but are not connected to any pins.
+"Degas can not be activated unless the IG pressure is below 5 x 10-5 in torr/mbar units, or 6.6 x 10-3 in pascal units."  The IG will also turn off after a few seconds if too high of pressure is detected (above 10-4 torr or maybe it as 10-5 torr).  Warning: if the collector cable is disconnected it will read something like 10-9 torr.
@@ Line 45: / Line 49: @@
 ^ Pin ^ Signal ^ Notes ^
-| 1 |  |  |
+| 1 | Anode grid |  |
-| 2 |  |  |
+| 2 | Filament |  |
-| 3 (raised) |  |  |
+| 3 (raised) | N/C | Structural: supports top of anode grid.  Electrically disconnected at STP |
-| 4 |  |  |
+| 4 | Filament |  |
-| 5 |  |  |
+| 5 | Anode grid |  |
 ===== Controller =====
@@ Line 56: / Line 60: @@
 {{:equipment:vacuum:gp:307:controller_back.jpg?600|}}
+===== Convectron tubes =====
+Looks like its designed for GP-275 tubes although the manual just says "Convectron" tubes.  Note that there is a module and a bare tube variant.  I believe that the module contains a bare tube except that it doesn't have the blue sheath.  More than likely you could steal one from another if need be
+Seems that Duniway Stockroom Corp. CVT-275-101 is a third party alternative.
 ====== References ======