Differences

This shows you the differences between two versions of the page.

--- signatone:micropositioner [2018/05/13 22:42] – mcmaster
+++ signatone:micropositioner [2019/03/05 00:41] (current) – removed mcmaster
@@ Line 1: / Line 1: @@
-{{:mcmaster:signatone:signatone_probers.jpg?400|}}
-{{:mcmaster:signatone:s-900_mostly.jpg?400|}}
-https://www.signatone.com/products/micropositioners/
-====== CAP-946 ======
-====== S-725 ======
-{{:mcmaster:signatone:s-725:725.jpg?150}}
-{{:mcmaster:signatone:s-725:parts.jpg?300}}
-The S-725 uses a gimbal mount at the front that pivots as the X or Z leadscrews are turned. These leadscrews put pressure against the leaf springs, noting the springs are not identical.
-To disassemble for leadscrew cleaning, loosen the gimbal and gently pull out the arm assembly. You do not need to remove the leaf springs. I also disconnected the final head on the pivot head so that I could fully detach the arm, which was connected via a cable epoxied to the case.
-{{:mcmaster:signatone:s-725:arm_assembly.jpg?300}}
-{{:mcmaster:signatone:s-725:leadscrew_cleaned.jpg?300}}
-{{:mcmaster:signatone:s-725:side_btm.jpg?300}}
-{{:mcmaster:signatone:s-725:side_front_empty.jpg?300}}
-{{:mcmaster:signatone:s-725:side_front.jpg?300}}
-{{:mcmaster:signatone:s-725:side_right.jpg?300}}
-{{:mcmaster:signatone:s-725:spring1.jpg?300}}
-{{:mcmaster:signatone:s-725:springs.jpg?300}}
-{{:mcmaster:signatone:s-725:vac_btm.jpg?300}}
-{{:mcmaster:signatone:s-725:vac_top.jpg?300}}
-====== S-900 ======
-====== S-926 ======
-====== S-M90 ======
-====== SP-100 ======
-====== SP-150 ======
-====== Economy ======
-{{:mcmaster:signatone:s-600_s-750_complete.jpg?400|}}
-Above: 3 S-750 at left, 2 S-600 at right
-===== S-600 =====
-===== S-750 =====
-"Economy Micropositioner" "The model S-750 was developed specifically for contacting larger areas (Pads)"
-Stats:
-  * Joystick ratio 9:1
-  * Probe scanning area 0.100” x 0.180”
-  * Vertical movement “Z” 0.50”
-  * Probe pressure: 10 grams