Differences

This shows you the differences between two versions of the page.

--- unixsurplus:dental_x-ray [2014/09/15 01:35] – mcmaster
+++ unixsurplus:dental_x-ray [2015/11/25 05:20] (current) – removed mcmaster
@@ Line 1: / Line 1: @@
-Info I've collected on the dental x-ray sensors that I got from UNIXSurplus at DEFCON 22.  These supposedly use USB.  Manufacturer or any other details unknown.
-WARNING WARNING WARNING
-Bond wires are exposed!  Be very very careful handing these!
-WARNING WARNING WARNING
-JM inventory:
-  * Unit: bond wires partially covered in glue.  Wires in perfect condition / intact
-  * Unit: bond wires ruffled but looks okay
-  * Unit: bond wires overall in good condition.  HOWEVER, a small section was ruffled and a wire broke (PCB side).  As they are aluminum I don't know if I can solder it
-  * Unit: bond wires in good condition.  No scintilator (and it looks like it never had one: no glue marks etc)
-  * Unit: in overall very poor condition.  No bond wires.  PCB has severe damage.  Sensor has severe damage.  Scintilator is damaged and separated from sensor
-====== USB interface ======
-TODO: solder wires to USB port and/or order cable
-====== PCB ======
-===== ProASIC3 =====
-  Actel
-  ProASIC3
-  A3P250
-  QNG132 1140
-  ZA637115
-====== Die ======
-No maker's mark observed on die.  There are some foundry marks but that probably won't be very helpful even if the foundry is identified