Table of Contents
SIM card from an old AT&T cell phone. No vendor logo, die copyright, or other identifying markings whatsoever.
Package
Die carrier
Die
Size is approximately 2000 x 1340 μm (2.68 mm2).
Top layer
The mesh appears pretty weak: one serpentine line zigzagging back and forth with ~850 nm pitch (probably 400-500 nm lines, consistent with the ~180 nm technology node). Since it appears there's only one net there would be no penalty for shorting adjacent lines together, or for cutting out a sizeable area and bypassing it.
Next layer down
HF etched until mesh removal, but not imaged yet.
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
