Differences

This shows you the differences between two versions of the page.

--- chemical:hno3 [2012/10/28 04:19] – mcmaster
+++ chemical:hno3 [2013/10/20 14:59] (current) – external edit 127.0.0.1
@@ Line 36: / Line 36: @@
 I do not know of any US suppliers that will sell RFNA to the average joe.
+====== Safety ======
+HNO3 fumes are very strong and should not be inhaled or come in contact with skin.  RFNA especially releases NO2 fumes.
+Nitric acid dries out skin and turns it yellow.  Takes two or three weeks to heal completely.  Example of nearly healed / peeling thumb:
+{{:chemical:hno3:hno3_thumb_healing.jpg?300|}}
+I find that using a 3M full faceplate respirator helps enormously.
+===== Gloves =====
+Both latex and nitrile is eaten by WFNA.  The areas of nitrile that aren't eaten completely eaten are weakened and must be replaced.  If fuming acid contacts latex/nitrile gloves, try to remove them quickly as it may eat through in a matter of a few seconds.  Likely the acid that makes it through won't be too strong but it will discolor skin and dry it out.
+Ultimately I use latex gloves because I often use acetone which rapidly eats nitrile gloves.  The above thumb picture was caused by acetone weakening a glove and subsequently causing nitric acid exposure.
+===== Compatibility =====
+Always test materials for compatibility before assuming that it will play well with nitric acid, especially the fuming variety.  In general, oxidizers, organics, and bases react violently with concentrated nitric acid.  Some key materials:
+  * Alcohol: reacts strongly, even at 70%
+  * Acetone: less strong reaction than alcohol, but fuming will self heat leading to explosion
+  * Nitrile: eats through
+  * Latex: eats through
+  * PTFE: teflon's nearly invincible so mostly no reaction.  However, some reactions self heat enough to cause it to decompose.  Particularly can be an issue when decapsulating ICs as it produces HF which is not only toxic but also etches the dies