Silicon Pr0n

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Inputs and outputs ======

In the previous module you came up with the pin numbering scheme and identified power and ground.  Now we'll go a little deeper to figure out data flow.

  * Identify the circle containing ESD protection
    * Detail
      * {{:quiz:metal_gate_cmos:esd_q.jpg?600|}}
    - A
    - B
    - C
    - D
    - E
    * [1]
    * (1)
    * Many chips use large parallel diodes for ESD protection and so this ones a little different.  However, ESD protection can often be identified by virtue of a component that attaches to both VDD and VSS.  While some of the transistors do this, they have logical connections that indicate they have a higher purpose.  ESD protection on the other hand tends to be very simple and regular.  Looking at the components in A I believe they are resistors as seen with NMOS logic (ex: see Intel 4004 die photos and Flylogic analysis).  Presumably this provides a more favorable conductive path and shunts away from the input gates.
      * B is a transistor
      * C is a transistor
      * D is a bond wire (ball bond)
      * E just has more metal and metal doesn't typically help ESD.  It can on larger chips when its used as a capacitor between VDD and VSS

  * Identify inputs
    * Detail
      * {{:quiz:metal_gate_cmos:iodir_q.jpg?600|}}
      * ie not outputs or power/ground
    - A
    - B
    - C
    - D
    - E
    * [1|4|5]
    * (1)
    * Anything with a fat transistor near the pad not connected to a gate is a pretty clear output or possibly tri-state.  I highlighted a gate on each questioned input, although keep in mind that simply having a gate attached to a pin doesn't make it an input as the circuit can have feedback or tri-state (necessary but not sufficient).  Going through each pin you see that each is either connected to only gates or only source/drain.  We can now identify all pins as either power, input or output.  D had to be traced to the other side of the die and is the lowest circled gate.
      * {{:quiz:metal_gate_cmos:iodir_a.jpg?600|}}