skip to content

Silicon Pr0n

User Tools

Log In

Site Tools

Recent Changes
Media Manager
Sitemap

Trace: • pad • resistor • fuse

recap

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

About protecting and storing chips after decap

Some options:
  * Tape over cavity: current standard practice.  Use Kapton.  When wrapped fully around is very strong
  * Slide coverglass glued to top: probably a good long term solution.  CA glue allows later removal
  * Nail polish: dries slowly.  Would need to be applied in thin layers.  Otherwise, think its pretty inert?
  * Hot glue: CTE might destroy bond wires

recap.txt · Last modified: 2016/12/23 18:58 by mcmaster

Page Tools

Show page
Old revisions
Backlinks
Back to top

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International