Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
cleaning [2013/11/17 07:15] mcmastercleaning [2013/11/17 07:18] (current) mcmaster
Line 165: Line 165:
  
 Shame on you if you picked up a die with your bare hands but things do happen.  Acetone does not clean off fingerprints very well but soapy water does.  The above picture was taken after putting a fingerprint on a slide and sonicating in acetone for a few minutes.  It has little to no effect.  Fingerprint oils do not respond to polarized light (ie will black out). Shame on you if you picked up a die with your bare hands but things do happen.  Acetone does not clean off fingerprints very well but soapy water does.  The above picture was taken after putting a fingerprint on a slide and sonicating in acetone for a few minutes.  It has little to no effect.  Fingerprint oils do not respond to polarized light (ie will black out).
 +
  
 ===== Polymide passivation ===== ===== Polymide passivation =====
  
-Can be removed with strong acids (eg RFNA).  Stilldoes not come off easily so other methods should be researched+General reccomendations: 
- +  * Oxygen plasma is probably best if you have access to it 
 +  * If you can deal with safety issuesethylendiamine may be next best 
 +  * Fuming nitric aicd works but takes a while This can potentially cause chip damage but shouldn't hurt Cu/Al if you keep the concentration high 
 +  * Piranha eats it quickly but it eats other metals nearly as quickly so its probably best avoided
  
   
 
cleaning.txt · Last modified: 2013/11/17 07:18 by mcmaster
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki