This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
decap:ceramic [2019/12/17 03:17] – [Bandsaw] mcmaster | decap:ceramic [2020/10/21 22:24] (current) – [Glass frit] mcmaster | ||
---|---|---|---|
Line 25: | Line 25: | ||
====== Glass frit ====== | ====== Glass frit ====== | ||
+ | |||
+ | 2020-10-21 | ||
+ | * General consensus may be that heating to below melting point (softens but doesn' | ||
+ | * Mind heat and cool cycles to avoid thermal shock | ||
JM 2016-11 advice: | JM 2016-11 advice: | ||
Line 114: | Line 118: | ||
* Saw a slit on both sides of the cavity | * Saw a slit on both sides of the cavity | ||
* As far as possible, usually about 0.1" after the quartz window | * As far as possible, usually about 0.1" after the quartz window | ||
+ | * Saw just into the glass frit | ||
+ | * WARNING: failing to completely separate ceramic can lead to unpredictable breakage | ||
* Should be roughly above where the bond wires attach but not above the die | * Should be roughly above where the bond wires attach but not above the die | ||
* Small debris in the cavity is normal and shouldn' | * Small debris in the cavity is normal and shouldn' |