If you use H2SO4 to remove the die you will end up with the leadframe and carrier island tangled among bond wires and the die. This page deals with techniques on separating those out.

Manual

If you only have one or two its probably easiest to just use tweezers and pick the leads off. However, this also has a larger chance of scratching the die (although this tends to be hard).

Chemical burn off

Most plastic carrier leads are made out of mostly copper with a silver plating (see vendor carrier materials for details). Nitric acid readily dissolves both. Use a 70% solution as RFNA/WFNA will overheat and decompose more than it will dissolve.

Alternatively, hydrogen peroxide and hydrochloric acid eats both although much less effective.

 
decap/leadframe.txt · Last modified: 2013/10/20 14:59 by 127.0.0.1
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki